Hi Guys.
There has been interest elsewhere for some nice billet radiator brackets.

Few improvements and provisions we have made over the factory one is the hole for the bolt on the radiator support is slightly elongated to allow for it being slightly off shape if it has been replaced or bent at some stage in its life.
Also have replaced the factory rubber grommet that holds the radiator to the bracket (that is no doubt flogged out) with a smaller rubber grommet supplied with the brackets. We have test fitted this on a PWR and a Koyo radiator and then fit nicely, a little more snug on a stock radiator but we figured if most people will have upgraded theirs buy now.



So we are looking to do a run of 20 sets, don't think we should struggle getting those numbers. Cut Off is SUNDAY THE 12th of JULY
So for a set you get the two brackets and 2 new grommets.

$130 Including GST for these plus $8.50 postage Australia wide (Or car arrange local pickup) . If we can't get 20 buyers it might be a little more expensive but again, I don't think that should be an issue.

If you guys could Only PM either myself or the Galvsport Facebook page directly that would be great. Just need to keep the group buys separate from the Galvsport day to day workshop.
Cheers!
Chris.