ITP Racecars
+ Post New Thread
Page 1 of 27 1 2 3 4 5 11 ... LastLast
Threads 1 to 20 of 528

Forum: Wheels, Suspension and Brakes

Discussion of wheels, tyres, suspension components and setup, brakes, etc.

  1. BF XR8 ute rear wheel bearings

    Hi guys, I've finally had enough of the noise from the wheel bearings being louder than the stereo in my ute. Have confirmed that it is the passenger rear that is noisy. Just wondering I anyone has done them before? Are the bearings and seals able to be changed independently of the hub? Or is it just a matter of changing out the hub. Also it appears that there is no nut holding the hub in so is there a circlip inside the di so the axle comes out with the hub? Can't find much online that...

    Started by evoeata‎, 06-10-2013 07:11 PM
    • Replies: 7
    • Views: 83,424
    25-02-2021, 06:43 PM Go to last post
  2. VS Statesman - lowering

    Hi all, Chasing ideas that need to meet the following - lower than standard - retain legal ride height - retain comfort to some degree - not bank breaking Thanks :)

    Started by TJ‎, 26-11-2019 10:53 AM
    • Replies: 1
    • Views: 37,581
    10-06-2020, 07:38 PM Go to last post
  3. 17" UHP tyres

    G'day, In the market for new tyres, 235/45R17 specifically. Anyone got some recommendations on good street tyres. Have had pilot sports 4, they're good, but would like a bit more feedback on the steering. Has anyone used them and the Bridgestone Re003? Any other recommendations in pleb sizing? All the best new tyres don't seem to be available under 19". Not really keen to run 'S compounds' like the SUR4G etc. Cheers.

    Started by beatle‎, 29-05-2020 11:21 AM
    • Replies: 3
    • Views: 4,135
    30-05-2020, 11:43 AM Go to last post
  4. 4 pot wrx calipers on sh forester

    Anyone know of they bolt straight up, the Subaru world is a confusing place. The stock brakes are fucking woeful.

    Started by Brett_J‎, 15-05-2020 12:43 PM
    • Replies: 1
    • Views: 4,038
    15-05-2020, 11:29 PM Go to last post
  5. Semi Slicks Tyre Recommendation

    Hey guys I need to replace my front tyres on the RX7 and can't make my mind up on what to get haha. Need 17s and they will be used mainly on track and street but mostly track days. Budget is roughly $200-300 ea. Tia!

    Started by patty‎, 12-07-2017 07:35 PM
    2 Pages
    1 2
    • Replies: 27
    • Views: 38,539
    02-02-2020, 02:27 PM Go to last post
  6. Commodore wheel offsets. VR vs VT

    Just wondering if anyone knows (fair few knowledgeable commodore people here) what VR wheels will sit like on a VT. Fairly similar to VT wheels of the same diameter and width or do they sit in/out? Some VR Senator 17's are on gumtree and looking to get them for my VT but don't want to be looking at requiring spacers so they at least look factory. Cheers

    Started by crabman‎, 12-01-2019 01:37 PM
    • Replies: 1
    • Views: 47,371
    12-01-2019, 04:34 PM Go to last post
  7. suspension repair

    Just wondering if anyone has replaced the spherical bearing on cusco camber arms and would happen to know what thread / size they are?

    Started by 180SXTCY‎, 27-12-2017 08:29 AM
    • Replies: 0
    • Views: 22,250
    27-12-2017, 08:29 AM Go to last post
  8. Thongbus coilovers

    What the fuck. Commodore forums have zero idea and information when it comes to coilovers, so AL question. What coilovers do I get for the ute? Currently Looking at HSD Monopro's Or Teins, Sport or Super Street

    Started by Riggs‎, 22-05-2017 04:07 PM
    • Replies: 13
    • Views: 21,311
    04-11-2017, 09:27 AM Go to last post
  9. VE commodore Axle tramp

    Guys with VE's, what have you done to eliminate axle tramp? So far Ive got a set of MCA purples and Super pro void fillers fitted with Super Pro Diff bushes to still fit. Was expecting the void fillers and coilovers to almost eliminate it but its hasn't. If diff bushed do the all fucking good, but failing that what is the best course of action? Extensive reading elsewhere has given all sorts of unfounded and nonsensical information. Wot do?

    Started by Riggs‎, 16-08-2017 09:30 AM
    2 Pages
    1 2
    • Replies: 31
    • Views: 29,480
    23-08-2017, 07:33 AM Go to last post
  10. R comp/semi slick tyre pressure

    Hey All, Just wondering what pressure semi's should be at, had a quick chat to Simon at the last supercruise but for the life of me can't remember. Running Federal RS-RR's Cheers

    Started by butters‎, 26-07-2017 03:22 PM
    • Replies: 9
    • Views: 18,596
    30-07-2017, 08:01 PM Go to last post
  11. Tyre softener

    Hi guys, long story short I put new Yokohama AD08 on my m3, 4 years before selling it. I have just bought the car back and owner has done 10,000kms in that time so Tyres still have plenty of tread. They are however production date 2010 and are quite slippery under fast shifting etc. Any tyre softeners out there to give them a new lease on life and make them bit more grippier or should I cut my losses and it's time to replace them? Also, he did put a new rear tyre (AD08R) which is prod...

    Started by Rajvosa‎, 06-07-2016 09:52 PM
    • Replies: 14
    • Views: 20,622
    23-05-2017, 11:31 AM Go to last post
  12. Wheel refurbishment/rash repair.

    Hey guys, Looking at getting some light rash on the panasports repaired and the barrels polished etc. Any recommendations anyone has used with good results. So far have only been put onto alliance, any others I should consider? Cheers.

    Started by ambi3nce‎, 24-08-2015 06:24 PM
    • Replies: 21
    • Views: 11,175
    22-05-2017, 02:43 PM Go to last post
  13. Rotor reccomendations

    Hi Guys, Recently put in a new set of QFM A1RM pads and RDA rotors in the front of my s13 (running the 280mm nissan 4 pot calipers) Took it to a tuning session at RAC on the weekend where they performed great, however the next day I found that under braking the steering wheel now shakes and the rotors are pretty scored up. Pads and Rotors were like a week old, calipers were just rebuilt. I guess the rotors are slightly warped and need a machine. However I want to try and avoid this...

    Started by Byah!‎, 16-11-2015 10:08 AM
    • Replies: 10
    • Views: 19,364
    23-01-2017, 08:44 AM Go to last post
  14. Will wheels that fitted on a bmw e60 530i fit on a e60 m5?

    As title states Wheels specs are 20x9.5 front 20x11 rear Unknown offsets

    Started by DenZel‎, 04-01-2017 04:01 PM
    • Replies: 24
    • Views: 10,893
    17-01-2017, 11:11 PM Go to last post
  15. R35 gtr wheels on fg xr6t

    Pretty sure it's been done on here before as I remember seeing a photo Tocchi , your presence would be appreciated Own a 2009 fg xr6t but should also mention running brembos and she is lowered (fg rears can't be rolled) Now I'm in a little worried about the 45/25 offsets Do they they foul the steering at the front? How much do they stick out? Etc etc

    Started by DenZel‎, 28-08-2016 07:00 PM
    • Replies: 9
    • Views: 22,530
    14-10-2016, 12:17 AM Go to last post
  16. Leaf springs - resetting/custom. Who?

    So with the 808 being lowered quite a bit, there is very little travel in the ass end. The front end is all good, being redone not long ago, but yeah, the back is is almost locked solid. I'll be getting under there this week and actually having a look to make sure the shocks aren't fucked, and the hangers all move the way they should, but in the meantime, does anyone have recommendations as to who to talk to about resetting leaf springs or getting a set made up?

    Started by monk_13‎, 01-08-2016 06:56 AM
    • Replies: 9
    • Views: 7,829
    02-08-2016, 07:28 PM Go to last post
  17. VZ SS Thunder Suspension info

    Hey guys, just after some solid info on the front suspension of a 2006 VZ SS Thunder ute. Are they the same as the sedan ? I know the rears are different, just wanting info on the fronts. How hard/expensive are the strut top bushes to replace? Is it worthwhile just changing the struts over? It's just a daily car so unsure if i want to fork out for front coilovers... yet.

    Started by Evilteddy‎, 17-06-2016 09:13 AM
    • Replies: 20
    • Views: 20,942
    27-06-2016, 08:57 AM Go to last post
  18. Vacuum pump / Brakes Issue

    Thought I would put up a thread of how this headache gets resolved. Background - I had a perfectly good 402ci motor in my Monaro, and brakes were first class. Changed motor to one from my old drag car - big solid cam, and made fuck all brake vacuum in drag car. Exactly the same issue now in Monaro Talked to a lot of people about my problem, and was assured a vacuum pump would solve it for me.

    Started by heavyduty1340‎, 20-06-2016 06:11 PM
    2 Pages
    1 2
    • Replies: 47
    • Views: 29,180
    25-06-2016, 01:02 PM Go to last post
  19. 18" Tyre Recommendatons

    Hi all, Recently I purchased some new rims and now im in need of some new tyres. Currently im running my stock tyres on the rims (245/40/R18) with a small amount of stretch, was wanting to know whats a good road tyre to run that has minimal noise. I'm currently running Dunlop Sport 600's - factory tyre that has lasted 35xxxkms, need some tyres that would last similar amount of kms. Thanks in advance.

    Started by Nickevox‎, 14-10-2013 06:36 AM
    2 Pages
    1 2
    • Replies: 35
    • Views: 38,364
    03-06-2016, 01:45 PM Go to last post
  20. Best wheel protectant/sealant

    Got new rims, want to keep them clean Best product? Autoglym, Meguairs, donkey jizz?

    Started by Lonewolf‎, 03-05-2016 11:29 AM
    • Replies: 10
    • Views: 19,640
    04-05-2016, 08:26 AM Go to last post

+ Post New Thread
Page 1 of 27 1 2 3 4 5 11 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts