Audio Visual help.

[SSICK]

Hey guys,

I have 7 TVs in 7 rooms that I want to display the same picture. As in plug a source in somewhere and have the video/picture/audio the same in each room. Ideally I want to cable it in RG6 quad shield as I have km of the shit. Also want to have free to air on each TV too. I have been told about RF modulators and needing an amp to run it all. I can do FTA no problem, just this multi display I've never done before.

Any help is appreciated.

Cheers
Tom

[2LMILK]

8 way hdmi splitter is the only thing i can think of as you only have 1x RG6 input (FTA)

Side note. got any RG6 you want to offload. i need a few more tv points in my house

[SSICK]

doing it HDMI is just as expensive as a 1 channel RF modulator. This way it all runs over the PAL (rg6) cable. Pretty much reverse a 2 way splitter and send the modulator signal and FTA signal backwards through the splinter into 1 cable. Digital tuner will pick up the extra RF channel.

But customer has canned it anyway. If anyone wants it done, I now know how to do it haha.

Neg on the RG6, I use it all the time.

[protecon]

2LMILK - I have about 250M of RG6 still on a roll if you need some.

[BASSULA]

Its expensive, Easiest way really is a proper network transmitter/receiver setup..

http://www.altronics.com.au/p/a3140-hdmi-over-ethernet-balun-extension-transmitter/ 1 of these and a gigabit switch

Any any number of these that you require.
http://www.altronics.com.au/p/a3141-hdmi-over-ethernet-balun-extension-receiver/

As said its no cheap but if you are wanting to transmit 1080p or the like is the best way.

[SSICK]

Yeah those tx rx are about $270ea and I'd need 5 of them. Could run it over cat6 but then need to convert to hdmi which is about the same. The rf modulator setup was around $1350.