Anaru
24-06-2014, 10:12 AM
For sale:
1988 Ae80 (Ae82) Toyota Corolla 4AGE 20v ST
Condition:
Not running, Surface Rust, Still licensed
Price and price conditions:
$3000 As is
Modifications
4AGE 20v Silvertop, only done 65,***km
MPR Custom Intake Plenum
Wilwood Calipers (Front Only) *
ISC Coilovers (Front and rear) *
Whiteline Sway Bars (Front and rear) *
Whiteline Lower Bar (Front Only) *
Whiteline Strut braces (Front and rear) *
TRD oil cap
TRD fuel cap *
TRD head gasket *
X-Speed cannon cat-back exhaust
Veilside Front bar *
C-West Side skirts
Droid Rear bar *
Aero Mirrors
Complete AE101 FXGT Loom conversion with Cluster
Custom dash with gauges
Ae82 FXGT Cluster hood (rare)
X-speed Daytona Bucket seats
Pioneer TSC130R component speakers in Custom door trims *
Carpet stripped interiour
(* denotes: not installed)
Contact Details:
PM would be best
Location:
Scarborough Area
Delivery & Conditions of Delivery:
So here's the deal. I've been traveling the world for the last 3 years pretty extensively and the project has fallen by the wayside. I'm only in Perth for the next month or so before I set off adventuring again so I have made the decision to sell the Corolla.
Since it's been sitting for so long the fuel system is gunked up and has slight surface rust since it was going in for paint before I left but never made it. Before the fuel went bad the car needed to have the correct vac line blocked (due to the plenum) to idle properly, if the OEM intake was to be re-installed it would run no problem.
Going for a fair price just judging by 1/2cuts going for almost the same not to mention the brakes and suspension worth 3k alone.
http://i5.photobucket.com/albums/y159/tan1wha/008.jpg
http://i5.photobucket.com/albums/y159/tan1wha/MyPhotos989.jpg
1988 Ae80 (Ae82) Toyota Corolla 4AGE 20v ST
Condition:
Not running, Surface Rust, Still licensed
Price and price conditions:
$3000 As is
Modifications
4AGE 20v Silvertop, only done 65,***km
MPR Custom Intake Plenum
Wilwood Calipers (Front Only) *
ISC Coilovers (Front and rear) *
Whiteline Sway Bars (Front and rear) *
Whiteline Lower Bar (Front Only) *
Whiteline Strut braces (Front and rear) *
TRD oil cap
TRD fuel cap *
TRD head gasket *
X-Speed cannon cat-back exhaust
Veilside Front bar *
C-West Side skirts
Droid Rear bar *
Aero Mirrors
Complete AE101 FXGT Loom conversion with Cluster
Custom dash with gauges
Ae82 FXGT Cluster hood (rare)
X-speed Daytona Bucket seats
Pioneer TSC130R component speakers in Custom door trims *
Carpet stripped interiour
(* denotes: not installed)
Contact Details:
PM would be best
Location:
Scarborough Area
Delivery & Conditions of Delivery:
So here's the deal. I've been traveling the world for the last 3 years pretty extensively and the project has fallen by the wayside. I'm only in Perth for the next month or so before I set off adventuring again so I have made the decision to sell the Corolla.
Since it's been sitting for so long the fuel system is gunked up and has slight surface rust since it was going in for paint before I left but never made it. Before the fuel went bad the car needed to have the correct vac line blocked (due to the plenum) to idle properly, if the OEM intake was to be re-installed it would run no problem.
Going for a fair price just judging by 1/2cuts going for almost the same not to mention the brakes and suspension worth 3k alone.
http://i5.photobucket.com/albums/y159/tan1wha/008.jpg
http://i5.photobucket.com/albums/y159/tan1wha/MyPhotos989.jpg