s13 seat rail, will it bold up to a r33 gtr seat

[Marti]

i know when fitting gtr seats to a silvia you normally need to weld a tab and drill it so that it lines up with the bold holes. But can i bolt a standard s13 seat rail onto a gtr seat with out needing to weld or cut anything ?, its a passanger seat aswell.

thanks

Marti

[Rich]

if R33 is the same as R32 then 3 out of the 4 bolts should line up. trying to remember back to when I put a set of R32 GTR seats into a 180. from memory it was the rear bolt closest to the trans tunnel that didnt line up.

[mitchy]

pretty sure the rails on 33 seats are part of the seat frame itself.

i tried pulling apart my 33 seats to put in my 31 and i vaguely remember it being a one piece rail/frame that holds the back/bottom of the seat together.

[Marti]

3 bolts line up fine its the front closest to the door that doesnt, if its one peice then i wont be able to switch them over. Might have to get a tab welded