joshg123
17-05-2009, 04:09 PM
Hi all, Doing an engine on stefs car, need a few parts to complete.
Vehicle is a 10/02 GD STI, engine is stock
Clutch throwout bearing to suit stock pull type clutch
Turbo oil feed line, there is 2 parts, one has the 17mm banjo going to block, the 2nd part goes from this pipe into turbo. i need the 2nd section, i also need the turbo oil lnlet fitting.
A stock middle section of exhuast, will purchase catback if required. NEEDS TO BE STOCK.
Also for an 02 WRX, however not STI i need
LHR hub without brakes, i need it for the dust shield behined caliper. Preferable to purchase complete hub ready to bolt on minus caliper and rotor.
Cash paid, PM, or 0405 443 412
Cheers
Josh
Vehicle is a 10/02 GD STI, engine is stock
Clutch throwout bearing to suit stock pull type clutch
Turbo oil feed line, there is 2 parts, one has the 17mm banjo going to block, the 2nd part goes from this pipe into turbo. i need the 2nd section, i also need the turbo oil lnlet fitting.
A stock middle section of exhuast, will purchase catback if required. NEEDS TO BE STOCK.
Also for an 02 WRX, however not STI i need
LHR hub without brakes, i need it for the dust shield behined caliper. Preferable to purchase complete hub ready to bolt on minus caliper and rotor.
Cash paid, PM, or 0405 443 412
Cheers
Josh