mrmek
27-08-2007, 07:53 AM
For sale:88 japspec vr4 4g63 turbo 4WD 10k
Condition: Reasonable
Price and price conditions:$10000 firm at the moment.
Extra Info
Engine
2.5" alluminium cooler piping.
450x300x76 front mount.
Evo 3 16g turbo
Evo 3 copy exhaust-manifold
3" Cat back
Blitz Dual SBC boost control
GFB plumback BOV
bosche 040 in tank fuel pump
Other
17" wheels
Hot bits sport DTM coilovers
whiteline big & adjustable rear swaybar
whiteline front strut brace
Tinting
Mp3 cd + 4 speakers.
Extra shit not installed and never used
Brand new KN filter
adapter and bigger AFM
Brand new Sard 700cc injectors
VR4 RS ecu with chip mapped to suit AFM, injectors and boooost
Brand spanker xtreme 9 puck sprung + cushioned semi ceramic clutch.
Palm and cable to datalog the new ECU
Custom Ceramic coated 3" Dump
Some 3" mandrel bends to make up a front pipe.
Other comments:
Removed Air con system, Remounted Oil cooler with soft lines. Relocated Thermo fan to make room for better intake setup. Removed rear spoiler. Removed Rear windscreen wiper.
Gripes:
Sparco suede wheel is worn
The intermittent setting for window wipers dont work.
Boot holes
Driveline noise, sounds like rubber bearings on drive shaft has bit o play. Been that way since i bought it 20k ago hasnt really got worse.
Clutch is weak, holds current 13 psi power just.
Turns over a fair few times when starting(always starts)
Working on mines, dont have the time these days to piss fart around and finish the mods. Aparently it should go pretty hard if you put in all the bits that i never did and feed it 17/20 psi. Not at all desperate to sell, dont want to swap for anything unless for some reason you dont like your evo7/8
Contact Details:PM me
Location:Perth
http://img518.imageshack.us/img518/1746/p1010228nz9.jpg
Condition: Reasonable
Price and price conditions:$10000 firm at the moment.
Extra Info
Engine
2.5" alluminium cooler piping.
450x300x76 front mount.
Evo 3 16g turbo
Evo 3 copy exhaust-manifold
3" Cat back
Blitz Dual SBC boost control
GFB plumback BOV
bosche 040 in tank fuel pump
Other
17" wheels
Hot bits sport DTM coilovers
whiteline big & adjustable rear swaybar
whiteline front strut brace
Tinting
Mp3 cd + 4 speakers.
Extra shit not installed and never used
Brand new KN filter
adapter and bigger AFM
Brand new Sard 700cc injectors
VR4 RS ecu with chip mapped to suit AFM, injectors and boooost
Brand spanker xtreme 9 puck sprung + cushioned semi ceramic clutch.
Palm and cable to datalog the new ECU
Custom Ceramic coated 3" Dump
Some 3" mandrel bends to make up a front pipe.
Other comments:
Removed Air con system, Remounted Oil cooler with soft lines. Relocated Thermo fan to make room for better intake setup. Removed rear spoiler. Removed Rear windscreen wiper.
Gripes:
Sparco suede wheel is worn
The intermittent setting for window wipers dont work.
Boot holes
Driveline noise, sounds like rubber bearings on drive shaft has bit o play. Been that way since i bought it 20k ago hasnt really got worse.
Clutch is weak, holds current 13 psi power just.
Turns over a fair few times when starting(always starts)
Working on mines, dont have the time these days to piss fart around and finish the mods. Aparently it should go pretty hard if you put in all the bits that i never did and feed it 17/20 psi. Not at all desperate to sell, dont want to swap for anything unless for some reason you dont like your evo7/8
Contact Details:PM me
Location:Perth
http://img518.imageshack.us/img518/1746/p1010228nz9.jpg